Drilling

Slow Spiral TCT Twist Drills

Slow spiral is sometimes preferred for drilling end grain in wood.

• Ideal for fast drilling operations in open grained material.
• Have a Solid Carbide ends, brazed in and ground to give maximum clearance.
• Have a 60 degree taper point and are recommended for hard or abrasive materials.
• These drills are not for use with routers and not suitable for masonry work.

Twist drill

Slow spiral is sometimes preferred for drilling end grain in wood. Ideal for fast drilling operations in open grained material. Have a Solid Carbide ends, brazed in and ground to give maximum clearance. Have a 60 degree taper point and are recommended for hard or abrasive materials. These drills are not for use with routers and not suitable for masonry work.

Multi-Bore Three flutes and no centre point

This machine bit is designed for recessing circular concealed hinges.

• The shank has a flat for securing and a grub screw for height adjustment.
• Use at recommended speeds of 6000RPM.
• Three flutes and three scribers.
• Specifically for use on thin boards.
• Gives a tear free blind hole.
• For use with stationary drilling machines only.

Multi-Borer Two flutes, no scribers and centre point

This machine bit is designed for recessing circular concealed hinges.

• The shank has a flat for securing and a grub screw for height adjustment.
• Use at recommended speeds of 10000RPM.

Multi-Boring countersink

This drill and countersink set are used extensively in the furniture industry.

• Features a TC tipped 60 degree taper slow spiral drill, as standard.
• Care should be taken to ensure flutes of drill align with flutes of countersink.
• Use at recommended speeds of 3000-6000RPM.

Multi-Boring dowel dril

This lip and spur dowel drill features Solid Carbide cutting tips, for continuous drilling of tear free dowel holes.

• Shank has one flat for positive holding.
• A threaded grub screw in the shank end allows for correct setting for a bank of drills.
• 57mm overall length.
• Negatively ground spurs for improved tear free holes.

Multi-Boring dowel drill

This lip and spur dowel drill features Solid Carbide cutting tips, for continuous drilling of tear free dowel holes.

• Shank has one flat for positive holding.
• A threaded grub screw in the shank end allows for correct setting for a bank of drills.
• 57mm overall length.
• Negatively ground spurs for improved tear free holes.
• Quantities of 10 are supplied in snap-off compartments.

Multi-Boring thru drill

This 60 degree taper multi-boring drill is ideal for end grain and through hole drilling applications.

• Reduces the likelihood of break out to a minimum.
• Drill has a Solid Carbide cutting tip.
• Shank has one flat for positive holding.
• A threaded grub screw in the shank end allows for correct setting for a bank of drills.
• 57mm overall length.

This adaptor is produced with a 10mm aperture.

• Will accept Ref. 4109, 4119, 4507, 1009, 1109 and 1209 drilling tools.
• The type of threaded shank may vary depending on the manufacturer of the multi-boring machine.