Drilling

Pre-moulded tenon dowels

Pre-moulded birch Tenon Dowel 3/8 inch.

Router cutters for making tenon dowels

Two fluted router cutter to machine own lengths of beadlock tenons.

V point HSS drills

HSS drill for use with the BL/JIG/95.

For fast and accurate joining of timber and plywood giving strong instant joints. Solid hardened bushes with variable pitch of 29mm to 63mm. Use on timber, MDF, plywood and blockboard. Allows a variety of joints to be created individually. Uses square drive self tapping screws. Workpiece can be handled immediately after gluing & screwing creating time saving benefits. No clamps required.

Slow Spiral TCT Twist Drills

Slow spiral is sometimes preferred for drilling end grain in wood.

• Ideal for fast drilling operations in open grained material.
• Have a Solid Carbide ends, brazed in and ground to give maximum clearance.
• Have a 60 degree taper point and are recommended for hard or abrasive materials.
• These drills are not for use with routers and not suitable for masonry work.

Twist drill

Slow spiral is sometimes preferred for drilling end grain in wood. Ideal for fast drilling operations in open grained material. Have a Solid Carbide ends, brazed in and ground to give maximum clearance. Have a 60 degree taper point and are recommended for hard or abrasive materials. These drills are not for use with routers and not suitable for masonry work.

Lip and Spur - HSS

These have 2 lips, 2 spurs and a centre brad point.

• Flutings are backed-off to give a radial relief and assist chip clearance.
• These groups of dowel drills are used mainly for drilling cross grained timber and particle board.
• These drills are not for use with routers and not suitable for masonry work.

Lip and Spur - Long Series HSS

These have 2 lips, 2 spurs and a centre brad point.

• Flutings are backed-off to give a radial relief and assist chip clearance.
• These groups of dowel drills are used mainly for drilling cross grained timber and particle board.
• These drills are not for use with routers and not suitable for masonry work.

Lip and Spur - TCT

These have 2 lips, 2 spurs and a centre brad point.

• Flutings are backed-off to give a radial relief and assist chip clearance.
• These groups of dowel drills are used mainly for drilling cross grained timber and particle board.
• Have tapered spurs.
• The complete drill head is made from Solid Carbide.
• These drills are recommended for hard or abrasive materials.
• These drills are not for use with routers and not suitable for masonry work.

90 Degree Shell Countersinks

These countersinks, produced from the best grade carbon steel, leaves a clean cut finish by virtue of their multi-tooth deep ground gullets.

• Fits metric drills from 3mm to 12mm inclusive.
• Not suitable for abrasive materials or metal.
• Drill bit not included.