Spiral

Ball End Up-cut

Solid Carbide long reach with superior performance in 3-D carving.

• Ball end to give clean transition between depths.
• Two fluted up-cut spiral.

Guided Spiral (Right Hand) Up-cut

Two flute spiral mini-trim with double guide bearing to profile intricate shapes.

• Max. 2.0mm trimming.
• Can be used on hard plastics such as acrylic, timber and manmade boards.
• Ref. S64/2 is upcut spiral.

Guided Spiral Down-cut (Left Hand)

Two flute spiral mini-trim with double guide bearing to profile intricate shapes.

• Max. 2.0mm trimming.
• Can be used on hard plastics such as acrylic, timber and manmade boards.
• Ref. S64/2LH is downcut spiral for veneered board.

Mini Up-cut (Right Hand)

Range of small diameter shank cutters for CNC routers.

• Used for specialised applications including signmaking & PRB machining.
• Up-cut prevents burning in plunge cuts.
• Two flute.

Mini Down-cut (Left Hand)

Range of small diameter shank cutters for CNC routers.

• Used for specialised applications including signmaking & PRB machining.
• Down-cut prevents feathered edges.
• Two flute.

Spiral (Right Hand) Up-cut

Ideal for use in CNC machines and for fixed head routing applications, can also be used in portable routers.

• Feed rates range from 5- 10m/min of 18000 - 24000 RPM.
• Ideal for hardwoods and abrasive material.
• Fine finish.
• Up-cut prevents burning in plunge cuts.
• High feed speed.
• Two flute.

Spiral Down-cut (Left Hand)

Down-cut spirals are ideal for routing small workpieces or for holding workpieces secure in vacuum jigs.

• Down-cut pushes woodchips below the work.
• Two flute.

Up-down Cut

Fine finish on both sides of solid timber.

• Ideal for edge trimming.
• For use on 16mm boards. Single fluted compression spirals.