Bevel Laminate Trimmers

Bearing guided adjustable chamfer cutter

Adjustable trimmer will trim and bevel the top and bottom edges of the workpiece.

• The width of workpiece accommodated can be adjusted with spacers.
• Trimmer blocks have four wings.
• Life of cutting edges can be extended with larger 26mm bearing Ref. BB26.

Bevel trim cutter

Cut a wider edge line, at an angle of 80 degrees.

• A 16mm bearing is supplied as standard.
• A larger 19mm bearing will spread the wear of the cutting edges.

Combi trimmer

A self-guided combination trimmer.

• A 90 degree trim is obtained by engaging the bottom half.
• A 45 degree trim is obtained by lowering the cutter.
• A fine height adjuster is recommended when using this cutter.
• A larger 20mm bearing will spread the wear of the cutting when 45 degree trimming.

Guided specialist bevel trim cutter

Cut a wider edge line, at an angle of 82 degrees.

• A 16mm bearing is supplied as standard.
• A larger 19mm bearing will spread the wear of the cutting edges.
• Has a gap between the tips and bearing, to reduce adhesive build-up.