Professional TCT Cutters

Diameters 13.0mm to 50.8mm

TCT for abrasive materials such as chipboard, MDF, plywood, hardwoods and hard plastics.

• Two flutes give a clean finish to cut edges.
• TCT plunge centre tip.

Eccentric single flute

Eccentric single flute cutters.

• Cutters are chosen for fast free cutting, when cutting speed takes preference over finish.
• Cutters with prefix S are Solid Carbide.
• Cutters of 2.0mm diameter and below should have a maximum of 1.0mm depth of cut per pass.
• Small diameter tools must be handled with care to avoid breakage.
• Single flute cutters should not be used in eccentric chucks.

Pin guided rebaters to follow work edges

The guide pin follows the work edge to give a preset width of rebate.

Single bladed straight Rota-tip cutters

Single flute replaceable tip router cutter

Two flute flush trimmers

For trimming the lipping of plastic overlay, and for rebating and machining wood, Duralium and plastics.

• Tungsten Carbide Tipped.
• Use at speed 12000 - 24000 RPM.

For dovetails joints and sliding dovetails.

For dovetail joints and sliding dovetails. To suit user preference, the table shows angles from the horizontal and the profiles show angles from the vertical.

Pin Guided Ovolo Cutters

Small solid guide pin can follow more intricate shapes in contrast to bearing guided cutters.

Pin Guided Round Over Cutters

Small solid guide pin can follow more intricate shapes in contrast to bearing guided cutters.

Ovolo edge

Cuts upper & lower ovolos and trims the edge between.

• Thickness Min.19mm - Max. 22mm.

Without bearings

Classic ovolo cutter.

• Use with a side fence.