Economy Laminate Trimmers

45/90 Degree Economy V Groove

Cutter for trimming and bevelling timber, lippings and plastic laminate.

• Can only be used in laminate trimming routers, or when straight fence guides are introduced.
• Solid tungsten carbide economy cutter.
• For use on short runs at 90 degrees or 45 degrees.
• Will trim and bevel by changing cutter height.
• Requires side fence or roller bearing.

60/90 Degree Economy V Groove

Solid Tungsten Carbide economy cutter.

• For use on short runs at 90 degree or 60 degree with Ref. S47/70, at 90 degree or 83 degrees with Ref. S47/71 and at 90 degree or 45 degree with Ref. S47/72.
• Will trim and bevel by changing cutter height.
• Requires a side fence or a copy follower guide on the router.

83 Degrees Guided

Solid Tungsten Carbide economy cutter.

• Self-guiding 90 degree trimming only with Ref. S48/39 & S48/40.
• Self guiding at 83 degrees with Ref. S48/41.
• Ref. S48/42 is for trimming on a rebate.
• The guide length is 3mm.
• Ref. S48/39 is a shorter version of Ref. S48/40.

83/90 Degree Economy V Groove

Solid Tungsten Carbide economy cutter.

• Self-guiding 90 degree trimming only with Ref. S48/39 & S48/40.
• Self guiding at 83 degrees with Ref. S48/41.
• Ref. S48/42 is for trimming on a rebate.
• The guide length is 3mm.
• Ref. S48/39 is a shorter version of Ref. S48/40.

90 Degrees Guided

Solid Tungsten Carbide economy cutter.

• Self-guiding 90 degree trimming only with Ref. S48/39 & S48/40.
• Self guiding at 83 degrees with Ref. S48/41.
• Ref. S48/42 is for trimming on a rebate.
• The guide length is 3mm.
• Ref. S48/39 is a shorter version of Ref. S48/40.

90 Degrees Guided Low Profile

Solid Tungsten Carbide economy cutter.

• Self-guiding 90 degree trimming only with Ref. S48/39 & S48/40.
• Self guiding at 83 degrees with Ref. S48/41.
• Ref. S48/42 is for trimming on a rebate.
• The guide length is 3mm.
• Ref. S48/39 is a shorter version of Ref. S48/40.