Panel Cutters

Bearing Guided Classic Panel

Shank mounted bearing follows template mounted on board surface.

• It is advisable that the template is at least 5mm thicker than the cutter.

Classic bearing guided

Ideal for following templates when panelling and profiling in furniture manufacture.

• It is advisable that the template is at least 5mm thicker than the cut length of the cutter.

Classic ogee

Edge moulds of classic proportions. Used to obtain decorative channels.

Flat Ogee

Produces an elegant edge mould, or a shallow panel effect when routing on its full width.

Ogee Panel

An unusual profile with three radii for use as an edge mould or for panelling applications.

• A thin splitting cut along the middle creates two attractive edge moulds.

Panel mould

Edge moulds of classic proportions. Used to obtain decorative channels.

• Ideal for thick table tops, frames etc.