Chucks

Standard quick chuck

• This is fitted into a standard 3/8 inch key or keyless chuck.
• Snappy attachments or any direct drive 1/4 inch hex bits can then 'snap' in effortlessly.
• Six flats on the shank ensure precise location in the chuck.
• A spring loaded outer sleeve makes it easy to remove attachments.
• Patent No. US5,398,946.

Extra long 3" quick chuck

• Extra long chuck in length with a smaller diameter head, to give ease of access.
• This chuck will accept both direct drive and insert type bits.
• Can be fitted to the Quick Chuck or directly into the drill chuck.

Extra long 6" quick chuck

• Extra long chuck in length with a smaller diameter head, to give ease of access.
• This chuck will accept both direct drive and insert type bits.
• Can be fitted to the Quick Chuck or directly into the drill chuck.

Hand Driver

• This quick chuck with a sturdy handle, allows the use of all Snappy shank direct drive tools.
• Supplied with a magnetic screwdriver holder and No.2 Pozi bit.

Hand Driver Set

• A Snappy chuck hand driver and 31 piece screwdriver bit set.
• Hand-driver allows certain Snappy shank direct drive tools to be used in applications where access is awkward or where a cordless can not be used.
• The 31 piece set covers all different screw fixing options.

Keyless chuck

• Keyless chuck that can be used in quick chucks and impact drivers to hold parallel shank drills bits up to 1/4 inch.
• Clamping capacity 0.8mm (1/32 inch) to 6mm (1/4 inch).
• Enhanced gripping power when compared to traditional key type drill chucks.
• Lightweight with plastic body.
• Fitted with Snappy shank 1/4 inch hex shank adaptor.

Magnetic quick chuck

• Magnetic chuck accepts Snappy shank fittings and Insert screwdriver bits (Magnet will hold wood screws when used with Insert bits).

SDS quick chuck

• For SDS plus drills.
• Hammer action must be switched off when used.

Snappy Direct Fit and Grip chuck

• The Snappy system starts with the Quick Chuck.
• This is fitted into a standard 3/8 inch key or keyless chuck.
• Six flats on the shank ensure precise location in the chuck.
• A sprung loaded outer sleeve makes it easy to remove attachments.
• Replaces existing chuck on drill.
• For drills with 3/8 inch-24 UNF spindle thread only.

Yankee quick chuck

• For 5/16 inch No. 131A Yankee Spiral ratchet screwdrivers (Large).
• The Quick Chuck replaces a standard bit and then enables Snappy tools to be used.