We use cookies to make your experience better. To comply with the new e-Privacy directive, we need to ask for your consent to set the cookies. Learn more.
Frequently Asked Questions
Router Tables FAQs
The AEG MF 1400KE will fit both our WRT and CRT tables but redrilling of the router table insert plate is necessary.
The GB/5/Q will not fit the Triton JOF001 you would need the GB/5/S which is no longer made but you could use the GB/5 and redrill to suit the JOF001 router base.
The RT0700 Makita trimmer can be fitted to our tables when coupled with the Makita 195563-0 plunge base. The table insert plate would need to be redrilled to accept this.
The T7EK router is designed for kitchen fitting etc., it was not developed for use in a router table. If you want to use it in our router tables, the router base and/or table insert plate needs to be drilled for mounting. The switch is also a momentary type “dead mans” so if you want to use in our router tables the switch would need to be strapped closed, in this mode a no volt release switch must be used. (Supplied with both the WRT and CRT/MK3 as standard.) The best way to transfer the holes from the router to the table plate is to remove the black plastic plate of the bottom of the router line this up centrally to the hole in the table plate and transfer the six fixing holes onto the table plate and counter sink.
There is a compatability button on the home page that lists all the makes and models of router and their compatability to Trend products.
The alloy track from the CRT/MK3 is available ref. WP-CRTMK3/38. The track is 600mm long with a neck width of 19.2mm
From the face of the back fence you can cut a groove with a maximum centre of 64.5mm.
The DW620 router fits both our WRT and CRT router tables without any modification.
No, not a direct fit.
The Makita RP2301FCXK can be fitted to our tables but redrilling of the table insert plate will be necessary.
The Ebauer ERB380ROU will fit our tables but re - drilling of the table insert plate is required.
The stud size is M10 and the machine screws are M5 countersunk.
What is the thread size of the CPL/02 lead on pin for use with the Craft Router Table insert plates?
The thread size is UNF1/4-28.
The diameter of the CRT/3 is 58mm.
Yes. with the use of part number CRT/3.
No, the T30/22 replaces the hose that comes with the T30 and will fit straight onto the CRT tables.
Use RTI/PLATE, this comes with alll the fixings necessary to make your own router table.
Our Trend T8, T11 and T14 routers both have the facility of adjustment above the table.