46/521X1/4TC - Guided 1mm rebater profiler for damaged trim

Name: 46/521X1/4TC - Guided 1mm rebater profiler for damaged trim
SKU: 46/521X1/4TC
Price: 80.14 GBP
Availability: InStock

46/521X1/4TC

£80.14

£66.78

Two fluted for clean finish, nose bearing to rout a rebate, and shank bearing to profile edge flush.

Ideal to remove damaged trim on tops to allow new trim to be added.
Tungsten carbide tipped for abrasive materials and is ideal for use on timber and manmade board.
Self guided with bearing on nose and shank.
Diameter of tool 16mm with 14mm diameter bearing nose.
Suitable for material 12mm thick to maximum 38mm thick.
Standard trim is 1mm with 14mm bearing.
Accessory bearings for 1.5mm, 2.5mm and 3mm lipping/edging available.

Product Image	Product Ref	Description	Price for 1
	B14F	Bearings are shielded to prevent penetration of dust and grease packed for life. They should not be cleaned with solvent or lubricated as this will dissolve the grease and cause premature bearing failure. Scrape off any resin build-up. Always check the tightness of the fixing screw before using cutter.	£15.42
	BB16	Bearings are shielded to prevent penetration of dust and grease packed for life. They should not be cleaned with solvent or lubricated as this will dissolve the grease and cause premature bearing failure. Scrape off any resin build-up. Always check the tightness of the fixing screw before using cutter.	£14.81
Out of Stock	COLL/14	Collar Packs are used for cutters with shank mounted bearings. Packs include one collar, grub screw and hex key.	£4.95
	SP-J	Spare part packs make ordering spares easier. Packs include, hex key (if required), screw, washer and shield (if required).	£2.83