C079X1/4TC - Rounding over 12.7mm radius x 19.1mm cut

Trend Router Cutter Bearing - for 3/16in bottom mounting

• High quality ball bearing for free running against an edge to prevent heat build up.
• 3/16in inside diameter for use on bottom mounted trimmer and profiling cutters.
• 1/2in outside diameter for matched fit to trimming and templating cutters.
• Bearings are grease packed for maximum efficiency and lifespan.
• Shielding to both sides of the bearing prevents penetration of dust for maximum performance.

Bearings are shielded to prevent penetration of dust and grease packed for life.

• They should not be cleaned with solvent or lubricated as this will dissolve the grease and cause premature bearing failure.
• Scrape off any resin build-up.
• Always check the tightness of the fixing screw before using cutter.

Spare part packs make ordering spares easier.

• Packs include, hex key (if required), screw, washer and shield (if required).