Frequently Asked Questions
Tag : Compatibility
Our Planer blades PB/29 will fit most modern Bosch planers where the blade is 82mm x 5.5mm slide in and out blade.
Yes they do, however a M5 nut and bolt is required to fasten them to the base of the router.
Please check our compatibility chart. A UNIBASE or sub-base may be required depending on the make and model.
No sorry the T5 router cannot be used with cutters of shank diameter larger than 8mm
Are the Elu collets ref E40102, E40103, E40107 still available for the Elu MOF131 and 177(E) router?
Trend can offer the T10 collets which will fit the Elu heavy-duty routers. Elu collet E40102 is Trend ref CLT/T10/635 (1/4 inch), E40103 is Trend ref CLT/T10/8 (8mm) and E40107 is Trend ref CLT/T10/127 (1/2 inch).
We do a range of replacement collets which are: 1/4" - CNS/T5/635 & 8mm - CNS/T5/8.
It will fit, if the T10 collet nut is used as well.
Some heavy duty routers like the T12/T14 can be a little heavy to handle, therefore the T4, T5 or the T18S/R14 are best suited.
There are a range of fine height adjusters available for a variety of routers. FHA/001 will fit Trend T5, Elu MOF96(E), Dewalt DW613, 615, Perles OF808(E), Draper R850V, Nu-tool NPT850, Power Devil PDW5027, Virutex FR78(C) and Wickes 900W.
The T7EK router is designed for kitchen fitting etc., it was not developed for use in a router table. If you want to use it in our router tables, the router base and/or table insert plate needs to be drilled for mounting. The switch is also a momentary type “dead mans” so if you want to use in our router tables the switch would need to be strapped closed, in this mode a no volt release switch must be used. (Supplied with both the WRT and CRT/MK3 as standard.) The best way to transfer the holes from the router to the table plate is to remove the black plastic plate of the bottom of the router line this up centrally to the hole in the table plate and transfer the six fixing holes onto the table plate and counter sink.
Yes, the Trend FHA/001 fine height adjuster can be used.
You would need the Unibase to connect the LN57X8MM guide bush to the T7E router.
There is a compatability button on the home page that lists all the makes and models of router and their compatability to Trend products.
Yes you can.
You can use the course side of your diamond stone for flatening a wetstone but this will affect the efficiency of the stone eventually.
The DW620 router fits both our WRT and CRT router tables without any modification.
No, not a direct fit.
The Makita RP2301FCXK can be fitted to our tables but redrilling of the table insert plate will be necessary.
The UNIBASE is required.
The Ebauer ERB380ROU will fit our tables but re - drilling of the table insert plate is required.
Yes. with the use of part number CRT/3.
No, the T30/22 replaces the hose that comes with the T30 and will fit straight onto the CRT tables.
Yes. A blade with a negative hook needs to be used to minimise ‘pick up’ and ‘snatching’.
This is just a recommendation because of the heavier weight of the router which makes if difficult to recess the top hinge on the door lining or frame.
