Frequently Asked Questions

Spare Parts FAQs

Frequently Asked Questions about Spare Parts

My Trend tool is out of warranty and it needs repairing where do i take it?

Trend uses C J Sinclairs. Ramsgate https://www.cjsinclairltd.co.uk they will pick up direct from you repair and also deliver back. They are also Trends warranty repair agent.

What is the part number for the 4mm feeler gauge in the hinge jig?

The part number is WP-HJ/10.

What other machines will a FHA/001 fine height adjuster fit?

There are a range of fine height adjusters available for a variety of routers. FHA/001 will fit Trend T5, Elu MOF96(E), Dewalt DW613, 615, Perles OF808(E), Draper R850V, Nu-tool NPT850, Power Devil PDW5027, Virutex FR78(C) and Wickes 900W.

Is there a fine height adjuster for the Nutool NPT850?

Yes, the Trend FHA/001 fine height adjuster can be used.

Do you offer a t slot track for installation into a user made router table.

The alloy track from the CRT/MK3 is available ref. WP-CRTMK3/38. The track is 600mm long with a neck width of 19.2mm

Is there a smaller bearing available for the two round over cutters in the starter set which will give you the bottom quirk?

A B63B will fit both cutters.

What bearing is required to change a 334X1/2TC cutter into a cutter for fitting a seal in the compression mode?

B35C is the bearing required.

What is the replacement spacer set for the Profile and Scribe sets in the professional range?

The part number is ref SPACER/8.

What is the replacement arbor on the Trend PSC profile scriber sets?

The replacement arbor is ref 33/30 on either a 8mm or 1/2 shank diameter.

What are the spare part references for the bearing and circlip for the RBT cutter?

The bearing is part no WP-RBT/CUT/A the circlip is part no WP-RBT/CUT/B

Can I purchase a pair of toggle clamps as a set for jig making?

Yes, the CR/H150/SET are a pair of medium-sized toggle clamps. The clamps have 150kg pressure and are ideal for fitting to jigs. The spindle is height adjustable and has a fixed rubber pad to protect the workpiece. The clamp can also be purchased individually (ref CR/H150).